808 Mini Camera Slug 'Donut Hole'

Model only.
This is the 'thick case' model for the 13.5 mm design.

This is larger in every dimension than the 808 mini camera.

It is intended as a model and as a negative for subtraction from other forms, to leave a hole.

Be prepared to clean up for plastic shrinkage on your holes, it might be a tad small in the corners some times. Not consistently.

To be the same size as the 808, reduce it by about 2%.

The model with the base is high enough off the heat bed to avoid any curling strangeness.
I suggest using the hex support, it comes off cleanest.

This is a Wades head mount for it. http://www.thingiverse.com/thing:32607

The '808 cam usb.stl' has a sufficiently large USB block to handle most mini usb plugs.

The hole half is a subtraction of the model from a form to see how well it fits, and it fits fine.

Pictures show the 808 next to the hole, in the hole, 808 in an early mount, the printed model in the same hole.

The hole half is half of the model subtr