Thingiverse
80mm spindle dust boot
di KJK
4
Download
0
Likes
0
Makes
Dust boot to fit an 80mm spindle body. 2 versions are available with either a screw on brush holder or a magnetic brush holder.
The boots require supports - custom supports are recommended to prevent introducing roughness in the air passages. Only the screw on brush holder needs a small support under the toggle used to assist in screwing the brush on/off.
I printed with 15% infill in either pla or petg.
The boot is tightened to the spindle using 5mm SHCS into threaded inserts. I used screw in inserts, but glued in ones also work fine.
The magnetic brush holder uses 10mmx2mm magnets which I obtained from Amazon. The brush was also obtained from amazon - links below.
https://www.amazon.ca/dp/B09QHRBKKK?psc=1&ref=ppx_yo2ov_dt_b_product_details
https://www.amazon.ca/gp/product/B07PXKK881/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
The boots require supports - custom supports are recommended to prevent introducing roughness in the air passages. Only the screw on brush holder needs a small support under the toggle used to assist in screwing the brush on/off.
I printed with 15% infill in either pla or petg.
The boot is tightened to the spindle using 5mm SHCS into threaded inserts. I used screw in inserts, but glued in ones also work fine.
The magnetic brush holder uses 10mmx2mm magnets which I obtained from Amazon. The brush was also obtained from amazon - links below.
https://www.amazon.ca/dp/B09QHRBKKK?psc=1&ref=ppx_yo2ov_dt_b_product_details
https://www.amazon.ca/gp/product/B07PXKK881/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!