Thingiverse
8520 motor mount - wing
di kb3006
5
Download
1
Likes
0
Makes
See original thing/file for typical thermoplastic FDM printing information if available.
I enlarged this remix, because my motors were too big after test print from Photon Mono (SLA). I also added a hole for wires in the back, and removed half of the mount, to make this an underwing mount for planes with a high wing.
I installed with hot glue, works fine.
Used "ERYONE" brand black "ABS-Like Resin" from amazon, with the following print settings on my Photon Mono SLA printer:
Layer thickness: 0.050
Normal Exposure Time: 3.50
Off Times: 0.5
Bottom Exposure Times: 40.00
Bottom Layers: 6
Anti Alias: 1
No raft, supports, or hollow. Rotated X or Y until biggest flat side with slot faces down, Z to center and avoid FEP stress.
Print Time: 52 Min
Resin Used (Calculated by slicer): ~3.182ml
I enlarged this remix, because my motors were too big after test print from Photon Mono (SLA). I also added a hole for wires in the back, and removed half of the mount, to make this an underwing mount for planes with a high wing.
I installed with hot glue, works fine.
Used "ERYONE" brand black "ABS-Like Resin" from amazon, with the following print settings on my Photon Mono SLA printer:
Layer thickness: 0.050
Normal Exposure Time: 3.50
Off Times: 0.5
Bottom Exposure Times: 40.00
Bottom Layers: 6
Anti Alias: 1
No raft, supports, or hollow. Rotated X or Y until biggest flat side with slot faces down, Z to center and avoid FEP stress.
Print Time: 52 Min
Resin Used (Calculated by slicer): ~3.182ml
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
