Thingiverse
8mm shaft collar
di jc61990
40
Download
31
Likes
1
Makes
Printed collar made to fit any 8mm smooth rod.
I used this specifically on my Printrbot Spool holder in place of the crappy wood one that would always fall off.
Just need one 3mm nut and a M3 x 10mm screw, I used one of the screws that held the two halves of the wood collar together.
Print with 2 shells and minimal infill. I got away with 15%.
It should be a snug fit.
I used this specifically on my Printrbot Spool holder in place of the crappy wood one that would always fall off.
Just need one 3mm nut and a M3 x 10mm screw, I used one of the screws that held the two halves of the wood collar together.
Print with 2 shells and minimal infill. I got away with 15%.
It should be a snug fit.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!