Thingiverse
9/16 nut cap
por Old-Steve
0
Descargas
0
Likes
0
Makes
My 9/16 nut cap
I recently replaced my patio and when I bolted down the new patio, then I had these anchors showing.
I bought 3/8 X 3 ¾ anchors. The nut is 9/16 or 14mm’s.
So I designed this little nut cap. It fits very snug on to the nut. There is a little room in the top of the cap in case you have some threads showing. I have room for 2 to 3 threads showing.
I put 2 caps on a common brim for an easy print.
I printed these in ABS since they will be outside. .2 layer.
I recently replaced my patio and when I bolted down the new patio, then I had these anchors showing.
I bought 3/8 X 3 ¾ anchors. The nut is 9/16 or 14mm’s.
So I designed this little nut cap. It fits very snug on to the nut. There is a little room in the top of the cap in case you have some threads showing. I have room for 2 to 3 threads showing.
I put 2 caps on a common brim for an easy print.
I printed these in ABS since they will be outside. .2 layer.
Old-Steve también publica en
1 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
