Thingiverse
90 degree corner bracket
von MeshifyUnity
6
Downloads
7
Likes
0
Makes
A very simple corner bracket! Intended to be hidden while still providing structural support.
Infill should not be less than 30%
PLA or any other material works fine
No supports needed to print!
Infill should not be less than 30%
PLA or any other material works fine
No supports needed to print!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
