MakerWorld
Decor
Go to Model
90º shelf support - 40mm Version
146
Downloads
19
Likes
50
Makes
90º shelf support. I used 4 per shelf to support a microwave and it's more than strong enough to hold it. I printed it on PETG just in case.This piece is 40mm wide as well as high, has 4 holes, 2 per side on opposite sides, so if you need to turn the bracket 180º, you can do it with the same holes.If you liked it or if it was useful, leave a comment and a like, it helps and motivates a lot.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
