Thingiverse
9600 Baud Modem Doorstop
door hoco
0
Downloads
0
Likes
0
Makes
KerrrrrrrrrrSheeeeeeeeePawwwwwwwwwwwGrrrrrdlrdlrdlrdlrrrrWeeeAhhhWeeeeeeeeeePink! Connect your door to the floor!
This print takes 3 hours and 27 minutes on my MKS3+, which is the same length of time it would take to download a 14.25 MB file over a 9600 baud modem. That is roughly 14 minutes of MP3 audio or a bit less than a minute of 1080p MP4 video.
If you have a bigger gap under your door you could either glue a sheet of rubber or felt underneath (also reduces slipping), or expand the print in the Z direction in the slicer.
I used variable layer heights, reducing the layer height at the top and bottom of the print to the minimum for a little smoother curve in the flattest parts.
Printed with Eryone Tricolor Silk Filament (black, purple & blue) using the Spool Rotator (https://www.thingiverse.com/thing:6114566)
This print takes 3 hours and 27 minutes on my MKS3+, which is the same length of time it would take to download a 14.25 MB file over a 9600 baud modem. That is roughly 14 minutes of MP3 audio or a bit less than a minute of 1080p MP4 video.
If you have a bigger gap under your door you could either glue a sheet of rubber or felt underneath (also reduces slipping), or expand the print in the Z direction in the slicer.
I used variable layer heights, reducing the layer height at the top and bottom of the print to the minimum for a little smoother curve in the flattest parts.
Printed with Eryone Tricolor Silk Filament (black, purple & blue) using the Spool Rotator (https://www.thingiverse.com/thing:6114566)
hoco publiceert ook op
121 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
