Thingiverse
9mm Ammunition Storage Case
par Overton_Prints
699
Téléchargements
1.7k
Likes
5
Makes
As of 11/6/24 the lids have been edited to open up the tolerance between the lid and case, let me know if it helps.
The two print files, “9mm lid" and “9mm case" Will ONLY fit rounds that are at or less than 1.1 inches. (Hollow points some ball ammunition)
The additional print files “9mm Top 1.169 Max” and “9mm Case 1.169 Max” should allow ANY standered 9mm round to fit without lid clearance issues. If your rounds are longer than 1.169 inches you probably have bigger issues than them not fitting in this case.
Print files can be printed on the same plate but if you are having surface quality issues I suggest printing separately.
Magnets (8x2mm) can be incorporated into the lid and case during printing. They give a satisfying "click" when the box is slid shut and do a good job keeping it closed. When the lid is removed it is inserted into the slot in the base of the case to push the rounds up for access.
Magnet Install:
The magnets are installed into the case durin
The two print files, “9mm lid" and “9mm case" Will ONLY fit rounds that are at or less than 1.1 inches. (Hollow points some ball ammunition)
The additional print files “9mm Top 1.169 Max” and “9mm Case 1.169 Max” should allow ANY standered 9mm round to fit without lid clearance issues. If your rounds are longer than 1.169 inches you probably have bigger issues than them not fitting in this case.
Print files can be printed on the same plate but if you are having surface quality issues I suggest printing separately.
Magnets (8x2mm) can be incorporated into the lid and case during printing. They give a satisfying "click" when the box is slid shut and do a good job keeping it closed. When the lid is removed it is inserted into the slot in the base of the case to push the rounds up for access.
Magnet Install:
The magnets are installed into the case durin
Overton_Prints publie également sur
27 modèles supplémentaires sur 1 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
