Thingiverse
Electronics
Go to Model
9v battery case
226
Downloads
157
Likes
0
Makes
Made this so I do not need to solder anything. I only need the battery and power cord.
And it is designed to not use a lot of material. (One top layer and one bottom layer should be sufficient to get a working model.)
FYI: If it shows up really small in your slicer try 2540% (somehow it confuses inch and mm)
And it is designed to not use a lot of material. (One top layer and one bottom layer should be sufficient to get a working model.)
FYI: If it shows up really small in your slicer try 2540% (somehow it confuses inch and mm)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
