Thingiverse
9v Battery Holder Case for Electronics Projects
von KimchiRobotics
3
Downloads
2
Likes
0
Makes
I couldn't find a 9v battery holder case for electronics projects so I made one for you.
I was tired of the terrible floppy, cheap, rippable 9v battery connectors and needed something more sturdy.
How to attach wires:
>You can loop some metal nickel tabs through the slots and solder your wires to them but careful because it can melt the PLA (headache).
>An easier and better option is to add some solder to solid core or braided wire that you loop through the slots a few times and pull the ends out the backside. Then solder your wires to those and cover with heat shrink tubing.
I already have an idea for improvements so stay tuned!
I was tired of the terrible floppy, cheap, rippable 9v battery connectors and needed something more sturdy.
How to attach wires:
>You can loop some metal nickel tabs through the slots and solder your wires to them but careful because it can melt the PLA (headache).
>An easier and better option is to add some solder to solid core or braided wire that you loop through the slots a few times and pull the ends out the backside. Then solder your wires to those and cover with heat shrink tubing.
I already have an idea for improvements so stay tuned!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
