Thingiverse
9v Flashlight Housing
door langfordw
47
Downloads
54
Likes
1
Makes
I decided to have a go at designing something 3D. This is a case for a simple 9v flashlight that uses a 9v battery, two 5mm LED's, a resistor, and a switch. It uses a snap joint to join the two parts.
I\'m not good with blender at all so I did it with Autodesk Inventor. You\'ll probably have to play with the orientation and stuff so that it will be printable.
--EDIT--
I removed the snap joint because I found it wasn't very printable (at least the way I had it) so the top just fits quite snugly on the bottom.
I\'m not good with blender at all so I did it with Autodesk Inventor. You\'ll probably have to play with the orientation and stuff so that it will be printable.
--EDIT--
I removed the snap joint because I found it wasn't very printable (at least the way I had it) so the top just fits quite snugly on the bottom.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
