9V PP3 Battery Holder

Cap and body that holds 12 9V PP3 batteries: the cap/body have notches that keep the cap relatively secure and recesses to allow pulling the cap off. The design is also stackable with a chamfer and hex in both the body and lid that hold together fairly well. The cap and body have text labels for easy reading (on all six sides of the body).

Tested prints at .3mm and 15% infill. At Prusa slicer default settings for .3mm draft this is about 5.23 cubic inches (1402 linear inches) of filament and takes about 6 hours to print.

Dimensions: 3.07" wide x 3.4" deep x 2.55" tall when assembled.

9V PP3 Battery Holder © 2025 by Paleflame is licensed under CC BY-NC-SA 4.0