A-10 Warthog Hueforge

I PRINTED THIS WITH 1 AMS, ASSIGN BLACK AND WHITE TO THE SAME AMS SLOT AND SWAP OUT THE BLACK WITH WHITE AFTER THE BLACK BASELAYER FINISHES. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size You may print at higher layer heights below the Min Depth of 0.48mm The Max Depth is 2.2mm and the Actual Depth is 2.2mmFilaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA PolyLite White Transmission Distance: 5This print uses 5 unique filamentsSwap Instructions: Start with Black At layer #9 (0.8mm) swap to Red At layer #13 (1.12mm) swap to Orange At layer #15 (1.28mm) swap to Yellow At layer #21 (1.76mm) swap to White for the rest.