A better Laptop Stand

There are a lot of laptop stands on Makerworld. But none I was quite happy with. This stand is similar to many others in the general design of two end plates (mirrored) connected by rails.The differences are as follows:Triangulated end plates, these are very sturdy. These are a little taller than most to better get the laptop up near the larger monitors most of us use.The 3mf file is a dual color design, but you can edit that however you want.Radius dovetails to prevent stress concentrations. I printed a few iterations of these to get the fit right using Bambu Lab PLA Matte. In case you want to use another type/brand of plastic I have made a plate that just prints the dovetail mechanism so you can check the fitment. They should be a firm press fit with fingers.Provision for cable ties on the rails. Or you can just thread the cables through the slots to improve cable management.Provision for anti-slip bumpers on the bottom. These are commonly available 8-10mm clear rubber stick on bumpe