Thingiverse
A Better Protractor/Angle Meter
von Creator2750
939
Downloads
648
Likes
8
Makes
Snap-fit assembly, no hardware required. Printed in 2 pieces.
I included the f3d file, in case some tweaks need to be made to the lever due to printer tolerances.
I did a color change during printing to contrast the numbers on the gauge.
Gauge is 160mm diameter as included, but should be scalable along with the lever. Total thickness is 10mm as is.
I included the f3d file, in case some tweaks need to be made to the lever due to printer tolerances.
I did a color change during printing to contrast the numbers on the gauge.
Gauge is 160mm diameter as included, but should be scalable along with the lever. Total thickness is 10mm as is.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
