A bird on a branch

A remix of a small bird found on thingiverse (one of three -- see https://www.thingiverse.com/thing:579484) and the result of a bit of backyard photogrammetry (the branch) done by a pal of mine. I scaled the finished remix down from the original sizes to 150mm tall for a nice fit on I3 sized machines.

I printed mine in transparent filament at 0.8 line with, 0.1 layer height, 0.8 wall, 1mm top and bottom, zero supports, and zero infill purely for artistic effect - though if using coloured filament or anticipate handling it a lot (inc. painting it maybe?) then perhaps 15% infill might not be a bad move. Mine took 6 hours to print on the settings shown and required only minor cleanup on the bottom of a couple of wayward overhangs.

Please Note: This archive now contains three new files two of which can be used for multi extruder printers:-
A Bird on a Bigger Branch.stl