Thingiverse
A Cheap table for 3D printer (anet a8)
von shivackt
60
Downloads
54
Likes
0
Makes
HAI EVERY ONE,
This is new table design for kept 2 Anet A8 printers. The design is made kept it mind that the table cost should be less. Hence the table is designed using available pvc pipe 40mm and 25mm pipes.
40mm pipe for legs and 25mm pipe for sides. that can u see in the pictures the table size is 22inch x 18 inch. 3 steps.
from the bottom 6" gap should be given then u place the another set at the middel.
the total height of the table is 4feet. the top one u can place the filaments.
Later u can enclose the table by using acrylic and magnets for easy access to printers. for printing ABS. the enclosure work is will be updated soon.
Thanks to all
This is new table design for kept 2 Anet A8 printers. The design is made kept it mind that the table cost should be less. Hence the table is designed using available pvc pipe 40mm and 25mm pipes.
40mm pipe for legs and 25mm pipe for sides. that can u see in the pictures the table size is 22inch x 18 inch. 3 steps.
from the bottom 6" gap should be given then u place the another set at the middel.
the total height of the table is 4feet. the top one u can place the filaments.
Later u can enclose the table by using acrylic and magnets for easy access to printers. for printing ABS. the enclosure work is will be updated soon.
Thanks to all
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
