A Go Pro Camera bracket

I wanted a mount for my go pro to make recordings of projects etc and therefore came up with this contraption. Yes it is a bit over kill but that was the idea. The hole in the cylinder will have a nut melted in so I can use a short bolt to hold it in various different lengths thats why there is a channel cut into the thread. As of yet it isn't off the printer so I can't really confirm if everything went to plan (gulp!) But I will of course update this after its printed.

When its all printed and cooled down, it connected up on the top left batch of four screws on the WANHAO i3 Plus They should line up perfectly.....(hmmm I love the word Should...)

Please remember I only started this in the last few days so there are bound to be an abundance of mistakes but thats the fun side - correcting them :)

Any advice or comments are welcome.

Regards to you
Marty