Thingiverse
A-Maze-Ing Cube
by tgandhi
110
Downloads
104
Likes
0
Makes
It's a maze! It's a cube! It's surprisingly addictive.
Fits 3/8" ball bearing (anything smaller than 10cm). Print one of each corner and 6 brackets. Corners are labeled, just match up the letters to the corresponding corners.
I also made a set that is pre-supported to help make sure they don't fall over while printing.
Fits 3/8" ball bearing (anything smaller than 10cm). Print one of each corner and 6 brackets. Corners are labeled, just match up the letters to the corresponding corners.
I also made a set that is pre-supported to help make sure they don't fall over while printing.
tgandhi also publishes on
4 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
