Thingiverse
A Simple Jumping Spider Perch
von hotdogbox
16
Downloads
32
Likes
0
Makes
PLEASE make sure you scale up to 105% or the magnets will not fit! I made the mistake of making the magnet insert the same size as the magnet.
A touch of hot glue will fix a 10x3mm magnet to the inside of the print.
I printed with PETG at:
-20% infill
-no support
-105% scale
Great for enclosures that are difficult to climb.
A touch of hot glue will fix a 10x3mm magnet to the inside of the print.
I printed with PETG at:
-20% infill
-no support
-105% scale
Great for enclosures that are difficult to climb.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!