Thingiverse
A Tiny Whoop "Gear" Box
by PMantix
18
Downloads
39
Likes
2
Makes
A Tiny Whoop "Gear" box for storage of:
x1 - 65mm Tiny whoop
x4 - 300mAh 1S cells
The battery tray is removable from the gear box - which I found to be more convenient. The top and bottom lids can either snap fit together or thread together. The snap-fit version is the intended option. The threaded version has only worked OK-ish for me as it's very easy to cross thread if you aren't careful about alignment before screwing the top and bottom together - So I'd only go with the threaded option if you are curious and / or OK with careful tightening of the lid.
The standard snap fit version worked well for me after I lubricated the snap fit area with a little bit of petroleum jelly. You may fit is a little tight for PLA, so I included .STLs with looser tolerance that might help. Probably still needs some refinement yet though!
The Tiny Whoop logo is slightly offset from the base surface for ease of multi-color print surface selection, but will print just fine without supp
x1 - 65mm Tiny whoop
x4 - 300mAh 1S cells
The battery tray is removable from the gear box - which I found to be more convenient. The top and bottom lids can either snap fit together or thread together. The snap-fit version is the intended option. The threaded version has only worked OK-ish for me as it's very easy to cross thread if you aren't careful about alignment before screwing the top and bottom together - So I'd only go with the threaded option if you are curious and / or OK with careful tightening of the lid.
The standard snap fit version worked well for me after I lubricated the snap fit area with a little bit of petroleum jelly. You may fit is a little tight for PLA, so I included .STLs with looser tolerance that might help. Probably still needs some refinement yet though!
The Tiny Whoop logo is slightly offset from the base surface for ease of multi-color print surface selection, but will print just fine without supp
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
