A1 / A1 Mini max flow test tower

This is yet another re-mix of the volumetric flow rate tower. See here for the source of this remix:https://makerworld.com/en/models/85600-bambu-slicer-max-flow-test-tower?from=search#profileId-91491 That one seems to be intended for higher flow rate 3D-printers like the X1C or P1S, (I think the original may have even been targetted at the Voron). My humble A1 Mini is not capable of such astronomic flow rates and I also tend to use thicker layers and wider line widths. This model has therefore been re-calibrated for the lower flow rates of the A1 Mini (this should also be appropriate for the A1). The tower now starts at a flow of 5 cubic mm per second and then increases by 1 cubic mm for every 1mm in model height. To use this model, run the print, stop it when you can see some obvious problems in the layers, then measure the height from the base to where the layer problems become noticable. The maximum flow rate is then the height you measured (in mm) + 5.i.e. Max Flow Rate (in mm³) =