A1 Mini Venting Bed Enclosure (V6)

For venting purposes, this is an alternative to using a full printer enclosure. It works great for venting out the window, or to a Hepa / Carbon filter. Note: For an inexpensive Hepa Filter venting solution, see my Hepa Filter Connector . Versions: v3. Tightened up gaps.v3. Removed some supports.v3. Improved clips and snaps.v3. Added an option to tighten the area around the heatbed cord if your cord is fairly straight (up and down), by adding 2 small parts that clip on the back.v4. Added outer circular rib to duct hose connection.v6. Added 2nd support leg to left panel.v6. Added a horizontal lip to the bottom of the right panel to block more air from the cable area.v6. Added the following options to improve Air Flow even more:Small clip-on parts to tighten up area around the bed cable. (Can use if your cable loop is vertical).Temporary clip on panel (for the top-front). Remove when printing models over 160mm height.Added a new panel which can be attached to the underside of the camera