A1 Printer Purge Catcher

This is a modification of a design obtained via a remix in the Bambu Studio online model browser, originally created by bylukg20 on Thingaverse, according to the credits of the post. This version is just intended to not need to be printed with anything else - Though as a side effect it can only hold the purge of two or three prints, not including color changing, plus it rattles a bit due to the constant movement, so I personally installed small duct tape pads in to silence that rattling. Most of the reason for this was solely so my printer poops didn't go flying off the back of my dresser, where my printer is. I just wanted a place for them to go until I went and picked them up, so I didn't have to stand there and wait for setup to complete. No assembly, just print and fit snugly onto the end of the printer. It should stay on just fine.