A1 PTFE Tube Guide

Update 10.01.25:I added a print profile with a stopper, which stops the guide from rotating further than parallel to the x-axis. Reason: I moved my AMS-Lite and the tubes were rubbing against the frame again, because of the 360° rotation. Introduction:Since I mounted my AMS Lite on my IKEA Skadis Pegboard right above my A1, I ran into the issue of having the PTFE tubes rubbing against the printer's frame, leaving marks on the surface.I searched for a solution and came across this tube guide made by Grebby, which is great, if your AMS stands next to the printer, but since mine is located on top, I noticed a lot of tension along the x-axis of the guide. So it's just a matter of time until it breaks. So I designed my own guide, which is able to rotate its base, swing up and down and rotate the tube guide (ring) itself, which allows it to move more freely. The model is partially inspired by the guide from Grebby, since I liked the design, even though it wasn't suitable for my p