A1 Touch Display Extender

A1 Touch Display ExtensionThis will extend the display UP 20mm RIGHT 20mm and BACK 20mm. It puts the left edge of the screen in line with the right edge of the printer base. No hardware or special tools are required for this modification. Simply print the extension and mount it between the screen assembly and printer base. I tested this in both PLA and PETG. PLA works fine but PETG is of course stronger and will hold up better. I went with the PLA for color match. COME ON BAMBU! What’s it going to take to get Light Gray PETG? 😊 *Something to considered before installation; Inspect the length of your ribbon cable to ensure it's long enough. When laid flat (parallel to the screen), my cable extended 9cm past the edge of the screen. If yours does not, this won’t work for you.To Install, follow Bambu Labs touch screen replacement guide. https://wiki.bambulab.com/en/a1/maintenance/touchscreen-replacement-guideBefore step one of the re-installation instructions:Clean the old lubricant f