A1 X-Axis Cable Guide (extra long)

For whatever reason, the original was a bit too short for my A1 by about 22mm, so I extended both pieces of the guide by 12mm, you can always trim it down a bit if needed. The holes were way too tight, so I decreased the height and width of the guide by 0.1mm (from 2x5mm to 1.9x4.9mm). Still really tight after decreasing the size, needed to sand it down a little but a few seconds is way better than a few minutes. And I find it redundant to have that insert for the filament cutter pole thingy, so removed that as well. Btw, the clips were not centered in that original print, and I'm OCD enough to fix that as well… P.S. Found this AMS Lite Hub quick release, and did a remix to make to fit over this cable guide. I highly highly recommend it, no more Y-Splitters, just a push of a lever and swap the hub. https://makerworld.com/en/models/1014448 Boost Me