A10 Filament runout mounting bracket

If you have the original Geeetech A10 that was supplied without a filament runout sensor, this may help you mount one.

I bought one of the items from ebay , link below.

Fit it to the existing mounting point by the extruder with a bolt, leave the bolt a little loose so the bracket can swivel, mount the switch sensor to the bracket as in the image again leaving the screw a little loose so that the sensor can pivot, lock the nut on the bolt with glue so that it does not work its way loose.

Here is a link to my alteration of the firmware, it may only be relevant to Marlin Version 2
https://www.facebook.com/download/preview/248176362533708

Sensor
https://www.ebay.co.uk/itm/3D-Filament-Detection-Module-Filament-Run-out-Pause-Detecting-Monitor-Sensor-EL/323457179135?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649