Thingiverse
A320 dummy foot rest
von astronaut7
2
Downloads
0
Likes
0
Makes
This is a dummy footrest I made for my A320 simulator.
Both parts can be printed without supports on a Bambu Lab P1S. I added an angled surface on the backside of the top piece (where it’s not visible) to ensure good bed contact. This allows it to be printed at a 45° angle using only a brim.
In two pieces to allow painting them separately.
Both parts can be printed without supports on a Bambu Lab P1S. I added an angled surface on the backside of the top piece (where it’s not visible) to ensure good bed contact. This allows it to be printed at a 45° angle using only a brim.
In two pieces to allow painting them separately.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
