A6 Fan/Sensor Bracket with M12x1 threads

This is a nearly trivial re-mix of https://www.thingiverse.com/thing:2703848 which is a remix of https://www.thingiverse.com/thing:2424312 I added M12x1 threads to the hole that holds the sensor.

The threads in the sensor are a very fine 1mm pitch. Having threads in the holder allows you to make actuate adjustment. for example after measuring you decide the sensor needs to by 0.25mm lower then you rotate it exactly 90 degrees and you know the exact amount you have lowered it.

Note the threads are very tight but loosen up after putting the sensor in and out a half dozen times. Hint - the sensor comes with two nuts and a lock washers. Place these on the sensor and jam them together tight. This make s good handle so you can turn the sensor into the plastic threads. Be very carful not to cross thread as it is very easy to do with these fine 1mm pitch threads

I used Fusion 360 to replace the hole in the STL file with an M12.1 threaded hole. Everything else was left a