Thingiverse
AA battery pack replacement
by xzw
14
Downloads
11
Likes
0
Makes
Print with support!
This is a battery pack replacement for a device that runs on 2 AA batteries. This printed piece is 2mm shorter than real batteries to accommodate a small screw on the the end to act as the electrical contact.
Make sure you test your power supply to have the correct polarity and voltage!
I have soldered the ends of the wires to the screws, and used the heat from my soldering iron to fit these back into the 3D printed plastic. If you try to screw in the screws, you'll almost certainly break the electrical connection.
This is a battery pack replacement for a device that runs on 2 AA batteries. This printed piece is 2mm shorter than real batteries to accommodate a small screw on the the end to act as the electrical contact.
Make sure you test your power supply to have the correct polarity and voltage!
I have soldered the ends of the wires to the screws, and used the heat from my soldering iron to fit these back into the 3D printed plastic. If you try to screw in the screws, you'll almost certainly break the electrical connection.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
