AAA Battery Box with Switch

I needed a AAA battery box with a switch so I could put it in a plaque and LED lite-up a hollow 3D printed temple.

For this project you need the following:
- If doing the same thing as me, LED's
- Battery Contacts
- Two pieces of wire (18 to 24 gauge, solid, not stranded ... I just use wires from Cat6)
- 2x M3 8mm long screws
- 2x M3 10mm self tapping screws
- 2x AAA batteries

Most of these parts you can find cheap on eBay in bulk.

A "Assembly Instructions.txt" file is included for directions, but below are those same instructions:

1. Print Parts
2. Slide battery contacts into their slots (may need a pair of pliers to get them in, it can be tight)
- Note there is one side of the box where the battery wire contacts leave the box, and the other side the battery contacts touch each other.
- The side where the contacts touch each other, it's easiest if you slide them into each other then slide them into their slot.
- Note the contacts are arranged so the ba