Thingiverse
AAAA Battery Holder
por Moehijaz
1
Descargas
1
Likes
0
Makes
This is a simple AAAA battery holder I designed because I did not see a dedicated AAAA battery holder I liked. This holds 8 batteries snuggly and the holes are only 25mm deep. The dimensions are 20x40x40mm
There is no need to rotate the model to print, the letters print just fine with its natural orientation.
I used an infill of 30% but Im sure smaller would be just fine. This model is not made for any stressful uses.
I used a 0.4mm nozzle with a resolution of 0.2mm
No supports needed
This was printed in PLA with nozzle temp of 200C and bed temp of 60.
I used adhesion with a brim but it probably was not necessary.
No post print processing.
There is no need to rotate the model to print, the letters print just fine with its natural orientation.
I used an infill of 30% but Im sure smaller would be just fine. This model is not made for any stressful uses.
I used a 0.4mm nozzle with a resolution of 0.2mm
No supports needed
This was printed in PLA with nozzle temp of 200C and bed temp of 60.
I used adhesion with a brim but it probably was not necessary.
No post print processing.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
