Thingiverse
AAP01 holster for TTI trigger
von Mul13r
106
Downloads
159
Likes
0
Makes
This is a Holster for AAP-01 with TTI trigger setup.
Hardware required:
2 M3x10 screws
4 M3x8 screws
4 M3 nuts
1 6mm diameter spring
Standard holster belt attachment (I used IMI Defense)
Note: This holster will work only if your trigger is set to a very short pull.
Hardware required:
2 M3x10 screws
4 M3x8 screws
4 M3 nuts
1 6mm diameter spring
Standard holster belt attachment (I used IMI Defense)
Note: This holster will work only if your trigger is set to a very short pull.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
