Thingiverse
ABUS Key cap
4
Downloads
4
Likes
0
Makes
I Printed that thing with Ninjaflex TPU first, works fine but is a little too soft. I then tried it with some other cheap TPU which is a little more stiff and worked perfectly. Does need support.
It may be possible to print it with PLA or something similar if you pause your printer right before the top layers, insert the key and continue printing.
It may be possible to print it with PLA or something similar if you pause your printer right before the top layers, insert the key and continue printing.
chokonmainatsu also publishes on
3 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
