Thingiverse
Abyssal Mirror / Infinity Mirror
von BeaconCat
778
Downloads
1.1k
Likes
1
Makes
This is a fun little electronic ornament with **programmable light effects** and **"infinite" depth!**
It can also be used as a small gift, or an abyss on the dinner table :D
Bill of Materials:
1.WS2812B Programmable LED Strip Light (Number of beads optional)
Can be replaced by any 1cm or shorter width strip, or you can modify the model by yourself
2.WeMos D1 Mini ESP8266 Development Board
For controlling lighting effects
Note: I have tested that even the version with 144 beads can be powered only by D1Mini without additional power input.
All mirror inserts are designed with a 1mm tolerance and can normally be inserted directly.(101mm*101mm square recess)
WLED is recommended for lighting control, for more information please visit: https://kno.wled.ge
Fabrication Guide:
1.Print the three-part shell.
2.Paste the WS2812B light strip to the inside of the center model, and lead the wire from the pre-determined 8mm hole.
3.Solder the WS2812B light strip to the c
It can also be used as a small gift, or an abyss on the dinner table :D
Bill of Materials:
1.WS2812B Programmable LED Strip Light (Number of beads optional)
Can be replaced by any 1cm or shorter width strip, or you can modify the model by yourself
2.WeMos D1 Mini ESP8266 Development Board
For controlling lighting effects
Note: I have tested that even the version with 144 beads can be powered only by D1Mini without additional power input.
All mirror inserts are designed with a 1mm tolerance and can normally be inserted directly.(101mm*101mm square recess)
WLED is recommended for lighting control, for more information please visit: https://kno.wled.ge
Fabrication Guide:
1.Print the three-part shell.
2.Paste the WS2812B light strip to the inside of the center model, and lead the wire from the pre-determined 8mm hole.
3.Solder the WS2812B light strip to the c
BeaconCat veröffentlicht auch auf
2 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
