AC Power Splitter

original model by @VectorConnec_2270492 AC Power Cord splitter (Kettle Cord) mk1 This was part of my 3D Printer enclosure projects to tidy up the cables on the back of the enclosure. Uses a standard chocolate bar electrical connector This design comes with: The body of the splitterclip-on top (screwless)a cable-hole top that can be screwed on (3M).a hole plug in case you don't need all 4 extensions. Cable hole diameter: 7mm Blender 4.2 Used. Note: I tried printing this with ABS first. However it's -7 degrees (C) outside so it warped. I had little patience so I printed it instead with PLA+ (the print in photo). ABS printed better (except for the warp) but, I think it might have something to do with the print settings not being adapted to the new enclosure yet - I will play with the settings a bit more. Anyway: PLA worked fine although I still believe ABS would be better.