Thingiverse
ACA Cyclone 120-C - Printable (V1)
von Existant
6
Downloads
3
Likes
0
Makes
~1/4 scale
Made on Tinkercad: https://www.tinkercad.com/things/cbxsqVpFdaw-cyclone-120-c-print-v1
PRINT ALL PARTS SEPARATE
Original HORN RING model goes to here (Matt Watson): https://www.printables.com/model/769754-14-scale-aca-cyclone-120125-siren (USE THE MODELS PROVIDED IN THIS THING OR ELSE IT WILL NOT BE COMPATIBLE WITH AN XD-3420 MOTOR.)
The stator and rotor should fit inside the housing with compatibility with an XD-3420 model motor.
WARNING - THIS MODEL IS ADVANCED AND REQUIRES LOTS OF PARTS AND MECHANISMS - PRINT AT YOUR OWN USAGE AND RESPONSIBILITY.
DO NOT SCALE ANYTHING IN CURA
Recommended voltage: 12VDC
Recommended amperage: 6A
Solenoid used (4 come in a pack, only one is required): https://tinyurl.com/4eua7bme
Made on Tinkercad: https://www.tinkercad.com/things/cbxsqVpFdaw-cyclone-120-c-print-v1
PRINT ALL PARTS SEPARATE
Original HORN RING model goes to here (Matt Watson): https://www.printables.com/model/769754-14-scale-aca-cyclone-120125-siren (USE THE MODELS PROVIDED IN THIS THING OR ELSE IT WILL NOT BE COMPATIBLE WITH AN XD-3420 MOTOR.)
The stator and rotor should fit inside the housing with compatibility with an XD-3420 model motor.
WARNING - THIS MODEL IS ADVANCED AND REQUIRES LOTS OF PARTS AND MECHANISMS - PRINT AT YOUR OWN USAGE AND RESPONSIBILITY.
DO NOT SCALE ANYTHING IN CURA
Recommended voltage: 12VDC
Recommended amperage: 6A
Solenoid used (4 come in a pack, only one is required): https://tinyurl.com/4eua7bme
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
