Slicer Discord
Accessory Friendly Deck Box – Modelo 3D imprimible de MakerWorld MakerWorld
Board Games

Accessory Friendly Deck Box

191 Descargas
87 Likes
128 Makes
Ver Modelo
I'm sure a lot of Pokémon TGC players use sleeves and accesories they get from Elite Trainer Boxes; I know I do. And I like to carry around all the accessory kit: health marker die, coin dice, status indicators, etc. I made this box specifically to fit a full deck of 60 cards with ETB card sleeves on (with enough give for maybe a few extra backup cards), and a tray for the accessories so they don't just slide around over the cards. The smaller compartment in the accessory tray is the perfect size to hold two full sets of ETB die (as pictured), and the other compartment is roomy enough for even the oversized coins they give with some themed decks… It also has a handy tab to pull it out of the box. The lid is attached via a simple hinge that allows it to open to about a 100 degree angle; which might seem strange but I like that it stays up like that. It's also adorned with a very subtle pokeball design (you can color that if you want, but I don't have a way to). It may be
Categoría
Board Games
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección