ACEPRO/2 "Dual Stack" with slide out lower tray

Description ACEPRO and ACEPRO V2 "Dual Stack" Upgraded to support both the ACEPRO and the ACEPRO2. Added support for the new Kobra X 3D printer. The Build plate holder will now support the larger Kobra X size. I added option for LED light bar to the bottom ACEPRO. I never could see in to see what was running low. Stack 2 ACEPRO units on top each other while allowing the bottom ACE to be pulled out to manage the filament. I printed everything on a K3C and Kobra X in PLA. My settings were; 0.2mm layer height. Infill = 15%. Wall Loops = 4. infill pattern = 3D Honeycomb. Width of Dual Stack is ~16.5in(42cm), Depth is ~16in(40cm), Height is 20.5in(52cm) Thats with none of the accessories attached and 15cm standoffs installed to keep it from the wall. Options for support of power or tool box on ends of the stack. Use the PTFE comb to manage the filament and run the PTFE tubes up and over the top of the printer, not to the left side. https://www.makeronline.com/en/model/Kobra%203%20PTFE%20Comb%20for%20single%20or%20dual%20ACE%20units%20and%20includes%20a%20Z%20Idler%20option/46694.html Combs https://www.makeronline.com/en/model/Kobra%203%20PTFE%20support%20combs%20to%20one%20or%20two%20ACE%20units/46840.html The model requires 34 M3x16 SHCS screws to hold everything together. No glue required. Affiliate Link: https://amzn.to/40nIDyz Optionally 6 pieces of 608ZZ roller bearings or the included printed part may be used but will not roll as well. Affiliate Link: https://amzn.to/40mlyfA requires 4 10mmx3mm refrigerator magnets. Affiliate Link: https://amzn.to/4fJYfkh Assemble the Tray first, Print TraySidePro2.3mf and TrayFront.3mf TraySideRightPro2, TraySideLeftPro2, TrayFront, The TrayFront plate has 6 plastic bearings and bushings. You can also use the Metal Bushings Insert the 8mm bushings into the bearings. Insert the 3 bearings into TraySideLeft/RightPro2. Use a M3x16 screw to fasten each bearing. Screws may not be needed. Insert 2 of the 10mm magnets in the ends of the