Thingiverse
ACR J10 Angled Foregrip
por 2manyhobbys
33
Descargas
23
Likes
0
Makes
Im printing this at the moment in two pieces, theres probably nothing too special about this grip and it may even be a piece of junk.. I just wanted to have a shot at designing one.
about 120mm long and 60mm tall.
I have tried to make the grip hug the handguard a bit tighter so not sure if it would fit on any other guns.
about 120mm long and 60mm tall.
I have tried to make the grip hug the handguard a bit tighter so not sure if it would fit on any other guns.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
