Thingiverse

Ada Robotic Hand

von openbionics

1.2k Downloads

1.2k Likes

1 Makes

Zum Modell

This is the Ada robotic hand from [Open Bionics](http://www.openbionics.com), a fully 3D printable robotic hand, derived from the Dextrus robotic hand by the [Open Hand Project](http://www.openhandproject.org/) .This hand design is completely open source and free for you to download and use.

All of the components required for a right hand start with 'R' and the components for a left hand start with 'L'.

A single hand requires the following 3D printed components:
- Palm
- Back Cover
- PCB Tray Upper
- PCB Tray Lower

Non-3D printed components:
- 9 x [M3 bolts (6mm length)](http://www.openbionics.com/shop/20-x-m3-bolts-and-inserts)
- 13 x [M3 threaded push inserts](http://www.openbionics.com/shop/20-x-m3-bolts-and-inserts)
- 1m x [0.7mm tendon string](http://http://www.openbionics.com/shop/tendon-line)
- 5 x [Firgelli 12V linear actuators (PQ12-30-12-P)](http://www.openbionics.com/shop/5-x-pq12-30-12-p)
- 1 x [Open Bionics Almond electronics](http://www.openb

bionics hand open bionics openbionics open source prosthesis prosthetic Prosthetic hand robohand robot robot hand robotic robotics robots bionics hand open bionics openbionics open source prosthesis prosthetic Prosthetic hand robohand robot robot hand robotic robotics robots bionics hand open bionics openbionics open source prosthesis prosthetic Prosthetic hand robohand robot robot hand robotic robotics robots

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat