Thingiverse
Adafruit Funhouse case
by Celly
3
Downloads
6
Likes
0
Makes
This is a case for the [Adafruit Funhouse](https://www.adafruit.com/product/4985) which I got in an Adabox, and didn't have any projects for at the time. Well, that all changed, and I needed a way to protect it.
There are 2 versions of the top. One with out holes for the LED's and the PIR points, and one with. The one without is probably best printed with transparent filament, and is an easier print due to less smaller holes.
I also didn't make the case snap, since it board already comes with nice thru-threaded standoffs, so some screws will be needed to finish it off.
There are 2 versions of the top. One with out holes for the LED's and the PIR points, and one with. The one without is probably best printed with transparent filament, and is an easier print due to less smaller holes.
I also didn't make the case snap, since it board already comes with nice thru-threaded standoffs, so some screws will be needed to finish it off.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
