Thingiverse
Adafruit MacroPad LCD Wedge
by srtnate
24
Downloads
15
Likes
0
Makes
After months of development, my team and I are pleased to present to you...this tiny little wedge.
I didn't love the visibility of the LCD with it flat on the PCB, and I felt it'd be much improved with a bit of an angle to it.
USE AT YOUR OWN RISK!!!!
This does require peeling the existing LCD off the PCB. I managed with my fingernail...just slowly applying some lifting tension, it gradually started to lift away. But again, BE CAREFUL, you could potentially damage the LCD.
I didn't love the visibility of the LCD with it flat on the PCB, and I felt it'd be much improved with a bit of an angle to it.
USE AT YOUR OWN RISK!!!!
This does require peeling the existing LCD off the PCB. I managed with my fingernail...just slowly applying some lifting tension, it gradually started to lift away. But again, BE CAREFUL, you could potentially damage the LCD.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!