Thingiverse
Adafruit PowerBoost 500C Case
por makersendinfo
10
Descargas
7
Likes
0
Makes
Small case for the Adafruit PowerBoost 500C LiIon/LiPoly battery charger.
* https://www.adafruit.com/product/1944
The lid is press-fit with no latches; printer settings and accuracy will affect how well it stays on (e.g., if you need a rubber band, maybe tweak some settings--if it's a bit too tight, minor sanding should be sufficient). We just needed something to keep it off the desk.
The board just drops in over the posts at the USB connector end. There are two hold-down pins on the lid to keep it from rattling around too much. If there's a need we can create a version that allows for a power connector on the output side.
* https://www.adafruit.com/product/1944
The lid is press-fit with no latches; printer settings and accuracy will affect how well it stays on (e.g., if you need a rubber band, maybe tweak some settings--if it's a bit too tight, minor sanding should be sufficient). We just needed something to keep it off the desk.
The board just drops in over the posts at the USB connector end. There are two hold-down pins on the lid to keep it from rattling around too much. If there's a need we can create a version that allows for a power connector on the output side.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
