Adapters for Wide USB SD/MicroSD holder

A set of adapters allowing you to use a part you printed a while ago, with newer tech. A set of shims for the excellent [USB SD and MicroSD holder for wide USB sticks by Lalo_Solo](https://www.thingiverse.com/thing:2637487) that converts the USB A cutout into a USB C cutout or slim USB A cutout.

These parts are super small and their awkward geometries don’t leave you with a ton of good options for print orientation. Additionally, the application necessitates a rather accurate shape and very tight clearance.

I had pretty good luck printing these out with the`.1mm DETAIL` profile in Slic3r Prusa Edition on my MK3s. The infill setting was 15% but I don’t think that really matters much at this size.

For the first several layers, I reduced the speed to about 30% of typical using manual speed scaler so I could “speed it back up” after I was confident that the base layers really had stuck down.


Each part took about 40min to print (I wasn’t kidding when I said I went SLOW on t