Thingiverse
Additional bit holder for BOSCH IXO
by jamnik89pl
4
Downloads
3
Likes
0
Makes
Holder for additional long bits for Bosch IXO to keep them in the box at an angle.
Originally in this place is an opening for manual.
To install my design the lip around the opening must be cut and depending on fit somtimes the holder must be glued in place.
Print with 0,16-0,20 layers with min 20% infill.
Originally in this place is an opening for manual.
To install my design the lip around the opening must be cut and depending on fit somtimes the holder must be glued in place.
Print with 0,16-0,20 layers with min 20% infill.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
