Additional chamber light for Bambu P1S

Frame for 11 LED at the right side of the chamber.

I used to print with an open printer (Anycubic i3 Mega S without chamber).
The chamber is an advantage at many points but it looks a bit dark inside the P1S even if the original LED stripe on the left side is on.

In combination with https://www.thingiverse.com/thing:7093526 or another switch or even without switch the chamber will be enlighten.

Additional material:
11 white LED 5mm 3V (3V2) 20mA
11 Resistor 100 Ohm
USB A plug
cable
Optional:
https://www.thingiverse.com/thing:7093526
or
another switch

To be mounted with doubl-sided tape on the right side exact opposite of the original LED stripe and connected to USB A port within P1S in the front, top (thx to BambuLab for providing that additional power source).

Printed in 45 minutes with 28g of filament (9m37)