Additional Drawer for IKEA HEMNES Bedside Table

Additional drawer for IKEA HEMNESWhile the IKEA HEMNES bedside table has a nice look and feel, it lacks in one aspect. The drawer is extremely small! This print adds two drawer runners to be able to use the 20x30x10 cm IKEA TROFAST as a drawer. You can mount the drawer runners with IKEA ALFTA double-sided tape refill, or with 4 x 20 mm screws. You could of course 3D print the drawer itself but as IKEA TROFAST is dirt cheap and happen to fit perfectly, I opted for only creating the drawer runners. If you are to use the tape, make sure to place the tape so that you can grab the blue part of the tape if you want to remove the drawer at a later time. The blue part should be to the back side of the runner, there will be too little space in the front to grab it.Mount the runner so that the wall part of the runners ends just before the leg, only the bottom part goes on the side of the legI doubt it would cause problems, but the mount part is just under the existing drawer and could potentiall